Canon JX200 ユーザーガイド

Troubleshooting

„

„

„

„

„

„

„

„

The remaining level of the ink cannot 
be correctly detected.

A FINE Cartridge that was once empty is installed. Replace the FINE Cartridge 
(see page 43).

The fax’s memory is full because it has 
received too many documents, or a 
very long or detailed document.

Print and delete any documents stored in memory (see page 34). 
Then start again.

The fax’s memory is full because you 
either tried to send or copy too many 
pages at once, or you tried to send or 
copy a very long or detailed document, 
using memory sending.

Free up space in the fax’s memory by printing or deleting any documents in 
memory you no longer need (see page 34).
If multiple pages are loaded, separate the pages into smaller stacks. If not, try 
sending the document by direct sending (see page 19).

The one-touch speed dialing button or 
coded speed dialing code you entered 
has not been registered.

Register the one-touch speed dialing button or coded speed dialing code (see 
page 13).

The fax received the document in 
memory because paper or ink ran out, 
a paper jam occurred, or the incorrect 
FINE Cartridge was installed.

Load paper in the Multi-Purpose Tray (see the Easy Setup Instructions), replace 
the FINE Cartridge (see page 43) or clear the paper jam (see page 53).
Print any documents stored in memory (see page 34). 

Ink is low.

Replace the FINE Cartridge (see page 43).

The document is set while printing.

Remove the document. Press [Stop] and try printing again.

The document cannot be correctly 
detected or the document is too small.

Make sure the document meets the requirements and is correctly loaded. If 
necessary, reload the document and press [Start/Copy]. See “Document 
Requirements” on page 15 and “Loading Documents and Paper” on page 16.

You pressed [Stop] to cancel the 
transmission.

If required, try sending again.