Canon iPF8400 マニュアル

Cause

Corrective Action

If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.

(See "Attaching the Roll Holder to Rolls.")

→P.536

Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.

Open the Top Cover and clean the entire Plat-
en.

(See "Cleaning Inside the Top Cover.")

→P.943

Insufficient paper for job

Cause

Corrective Action

The printer has received a print job longer than the amount of roll paper left when Man-
ageRemainRoll in the Control Panel menu is On.

Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
When using the Media Take-up Unit, press ▲ or ▼
to select Print, and then press the OK button to re-
sume printing.
However, the roll paper may run out during the print
job and you may not be able to print all of the docu-
ment.

Press ▲ or ▼ to select Change Paper, and then
press the OK button.
Change the Paper Source of the printer driver, or re-
place the roll with a roll that has enough paper for
the print job, and then printt.
When using the Media Take-up Unit, press ▲ or ▼
to select Stop Printing, and then press the OK but-
ton to stop printing.
Remove the printed document from the Media Take-
up Unit, replace the roll with a roll that has enough
paper for the print job, and then try printing again.

(See "Removing the Roll from the Printer.")

→P.545

(See "Loading Rolls in the Printer.")

→P.539

(See "Removing Printed Documents from the Media
Take-up Unit (Optional).")

→P.586

Press ▲ or ▼ to select Stop Printing or press the
Stop button to stop printing.

This paper cannot be used as size is not supported.

Cause

Corrective Action

Paper that is too large for the printer has been loaded.

Lift the Release Lever and load paper of the correct size.