LXE mx6 ユーザーガイド

26 

Enter Data 

MX6 User’s Guide 

E-EQ-MX6OGWW-E 

Use the MX6 imager and the laser scanner to scan, decode, and store information from barcodes. 
The barcoded data must be “read” into an application or field or the imaged data will be lost. 

Do not pour, spray, or spill any liquid on the imager/scanner housing. The Integrated Imager 
and barcode scanner housing contain the circuitry, scanning motor, imager (and/or laser). 
Handle with appropriate care. 

Read all cautions, warnings and labels before using the imager or barcode 
scanner. 

These actions should be performed by the System Administrator before the MX6 is placed into 
service. Please refer to Chapter 4 System Configuration in the MX6 Reference Guide for 
instruction. 

Please refer to the MX6 Reference Guide, Chapter 6 section titled Scanner/Imager Parameter 
Setup. 

Select  Start | Settings | System | Scanner and set up scanner parameters before scanning a 
barcode. See Chapter 4 “System Configuration”. 

 

To use the scan beam, aim the top of the MX6 at a barcode and press the Scan key or press the 
trigger on the handle. The decoding engine scans as long as the key or the trigger is held down 
before the 10 second timeout occurs. 

•  Scan LED is on the right. When illuminated red, the MX6 is scanning a barcode.  
•  Decode LED is on the left. When illuminated green, the MX6 scan algorithm accepts the 

barcode as a “good scan”.    

The beam turns off automatically when a barcode is read successfully.