LXE mx3plus ユーザーガイド
Storage Cradles
47
E-EQ-MX3PLUSOGWW-B
MX3Plus User’s Guide
Vehicle Mount Cradle for MX3Plus
This cradle is specifically designed for vehicle mount applications. The cradle restrains the mobile
device and isolates the computer from shock and vibration. The MX3Plus is inserted into the
cradle by placing the base of the unit in the pocket and then firmly pressing the unit backwards
until the release mechanisms latch and hold the unit in the cradle. The MX3Plus is removed from
the cradle by pressing the release mechanisms and pulling the MX3Plus up and away from the
cradle.
device and isolates the computer from shock and vibration. The MX3Plus is inserted into the
cradle by placing the base of the unit in the pocket and then firmly pressing the unit backwards
until the release mechanisms latch and hold the unit in the cradle. The MX3Plus is removed from
the cradle by pressing the release mechanisms and pulling the MX3Plus up and away from the
cradle.
Connectors
The Power connector is located on the back of the cradle below and to the left of the RS-232 port.
The cradle is powered by either a vehicle's 12V battery or from an approved accessory for vehicles
with higher voltage (24 to 60 VDC) batteries. When powered, the cradle transfers external power
to the MX3Plus, which in turn, recharges the main battery. A powered cradle allows RS-232 and
IR communication.
The cradle is powered by either a vehicle's 12V battery or from an approved accessory for vehicles
with higher voltage (24 to 60 VDC) batteries. When powered, the cradle transfers external power
to the MX3Plus, which in turn, recharges the main battery. A powered cradle allows RS-232 and
IR communication.
The RS-232 connector is located on the back of the cradle below and to the right of the power
connector. When the MX3Plus is properly docked, the bi-directional half-duplex transceivers in
the MX3Plus and cradle are aligned through their IR windows. The half-duplex IR signals from
the MX3Plus are converted to RS-232 signals in the cradle and available at this connector.
connector. When the MX3Plus is properly docked, the bi-directional half-duplex transceivers in
the MX3Plus and cradle are aligned through their IR windows. The half-duplex IR signals from
the MX3Plus are converted to RS-232 signals in the cradle and available at this connector.
Note:
ActiveSync will transfer files over the RS-232 connector on the vehicle cradle.
ActiveSync with a Cradle
To ActiveSync, the cradle must be powered off, the ActiveSync cradle cable attached to the
desktop PC and the cradle, then the cradle powered up.
desktop PC and the cradle, then the cradle powered up.
Note:
ActiveSync transfers files to the MX3Plus over the RS-232 connector on the cradle using
the MX3X070CBLD9RS232AS cable.
the MX3X070CBLD9RS232AS cable.
Figure 32 ActiveSync Cable Connected to Serial port on Cradle