Canon lbp-1760 ユーザーガイド
140
Skipping error messages temporarily
Messages in the Messages Table marked with an arrow enclosed in a circle ( ) relate
to minor problems that can be skipped temporarily. Overriding an error is only a
to minor problems that can be skipped temporarily. Overriding an error is only a
temporary measure that allows you to complete the current print job.
1
Where an error can be skipped, press
Go
.
2
If the error can be skipped, you can complete the current print job. To cancel the
message permanently, refer to the Messages Table and correct the problem (see page
134).
message permanently, refer to the Messages Table and correct the problem (see page
134).
Skipping error messages does not remove the cause of the problem. It only
allows you to complete the current print job. Unless you take immediate
action to solve the problem, the same error may occur again with similar
print jobs.
allows you to complete the current print job. Unless you take immediate
action to solve the problem, the same error may occur again with similar
print jobs.
Setting the printer to skip errors automatically
Follow this procedure to set the printer to skip minor error messages and automatically
resume operation. With the automatic continue feature on, when a minor error occurs
the printer will display the message, pause for 10 seconds and automatically resumes
the printer will display the message, pause for 10 seconds and automatically resumes
normal operation.
This feature only works with minor errors. Errors that can be skipped are
marked in the Messages Table ( ) (see page 134).
marked in the Messages Table ( ) (see page 134).
1
Press
Go
to take the printer off-line. At this time, make sure the
On Line
indicator
is off. The READY message will change to PAUSED.
2
Press
Menu
to display the first menu title (PCL MENU) in the top line.
3
Press
Menu
repeatedly until you see CONFIG MENU in the top line.
4
Press
Item
to display the first item on the menu (JAMRECOVERY) in the bottom line.
5
Press
Item
until you see AUTOCONT=OFF in the bottom line.
6
Press
Value
to select AUTOCONT=ON.
7
Press
Enter
to save the selection.
8
Press
Go
to put the printer back on-line.
Responding to Error Messages