Ricoh fax3310l ユーザーガイド
Windows NT 4.0 Configuration
28
4
Setting Up LPR Printing
Follow these steps to set up LPR printing.
Note
❒ In the following instructions, some fields or dialog box names may differ de-
pending on the NT service pack in use.
A
Configure the IP parameters on the Network Interface Board using the op-
eration panel.
eration panel.
Reference
For more information about setting IP parameters, see “Configuring the
printer for the Network with the Operation Panel” in “Printer Reference 1”.
printer for the Network with the Operation Panel” in “Printer Reference 1”.
B
Click [Start] on the taskbar, point to [Settings], and then click [Control Panel].
C
Double-click [Network] and select the [Protocols] tab to confirm that the TCP/
IP protocol is installed.
If the TCP/IP protocol is not in the list of Network Protocols, click [Add] to in-
stall it.
IP protocol is installed.
If the TCP/IP protocol is not in the list of Network Protocols, click [Add] to in-
stall it.
D
Select the [Services] tab.
If Microsoft TCP/IP Printing is not on the list of Network Services, click [Add]
to install it.
If Microsoft TCP/IP Printing is not on the list of Network Services, click [Add]
to install it.
E
Click [Close] when all protocols and services have been added.
If the TCP/IP protocol has just been added, set the IP address and other TCP/
IP parameters.
The new protocols and services will be available after the system is restarted.
If the TCP/IP protocol has just been added, set the IP address and other TCP/
IP parameters.
The new protocols and services will be available after the system is restarted.
Important
❒ If the printer driver has not been installed yet, install it before continuing.
F
Click [Start] on the taskbar, point to [Settings], and then click [Printers].
G
Right click the appropriate printer and select [Properties].
H
On the [Ports] tab, click [Add Port].
I
Double-click [LPR Port] in the list of available printer ports.
J
In the [Name or address of server providing lpd:] field, type the IP address of the
Network Interface Board (that was assigned with the operation panel).
Network Interface Board (that was assigned with the operation panel).
K
In the [Name of printer or print queue on that server:] field, type “PORT1” (quo-
tation marks are not included) in capital letters and click [OK].
tation marks are not included) in capital letters and click [OK].