Ricoh fax3310l ユーザーガイド
7.7 Running Telnet
TCP/IP Configuration
7-13
•
If you do not make a menu selection for two minutes, you get a two-minute
warning that within two more minutes your Telnet session ends. This ensures that
no one user leaves a session idle for too long.
warning that within two more minutes your Telnet session ends. This ensures that
no one user leaves a session idle for too long.
7.7.1 Making the Connection and Accessing the Main Menu
To make the connection and access the Main menu:
1.
At the prompt, type the following command:
telnet ip-address
where ip-address is the IP address of the card.
2.
When the login prompt appears, type
guest
if you are interested in only browsing
the menus, or type
sysadm
if you want to change the configuration.
3.
When the password prompt appears, again type
guest
or
sysadm
.
The main menu is displayed. This utility lets you change the IP parameters,
lpd
/
lpr
printers, protocols, and password, and lets you restore to factory
defaults.
4.
Type the number for the parameter you want to check or change and press Enter.
5.
To end your Telnet session, type E at the Main Menu.
If you have made any changes you are prompted to either Save Changes and Exit
or Exit Without Saving Changes. Choose the appropriate option and press Enter.
or Exit Without Saving Changes. Choose the appropriate option and press Enter.
Note:
To get online help in Telnet, type ? (question mark).
1. IP Parameters
2. LPD Printers
3. Protocols
4. Restore Factory Defaults
5. Change Password
E. Exit
2. LPD Printers
3. Protocols
4. Restore Factory Defaults
5. Change Password
E. Exit