Ricoh AP400 ユーザーガイド
Remote Maintenance by telnet
103
7
EEEE
Type “yes” to save the changes, and then press the
{{{{ENTER}}}} key.
If you do not want to save the changes, type “no”, and then press the
{{{{ENTER}}}}
key. If you want to make additional changes, type “return” at the command
line, and then press the
line, and then press the
{{{{ENTER}}}} key.
Note
❒ If the “Cannot write NVRAM information” message appears, the changes
are not saved. Repeat the steps above.
❒ The Network Interface Board is reset automatically when the settings are
changed.
❒ When the Network Interface Board is reset, the active print job which has
already been sent to the machine will finish printing. However, jobs that
have not been sent yet will be canceled.
have not been sent yet will be canceled.
Commands List
Use this command to display remote maintenance use.
Note
❒ Type “help” to see a list of commands that can be used.
msh> help
❒ Type “help command_name” to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the ifconfig command to configure TCP/IP (IP address, subnet mask, broad-
cast address, default gateway address) for the machine.
cast address, default gateway address) for the machine.
❖
❖
❖
❖ Reference
msh> ifconfig
❖
❖
❖
❖ Configuration
msh> ifconfig interface_name parameter address
Interface name
Interface to be configured
ether
nc0
Ethernet Interface
ip1394
IEEE 1394 Interface
wlan
IEEE 802.11b Interface