Ricoh AP400 ユーザーガイド
Windows XP/Server 2003 Configuration
40
3
Configuring a Windows XP/Server 2003 computer
Follow these steps to configure a Windows XP/Server 2003 computer to use the
TCP/IP protocol.
TCP/IP protocol.
AAAA
Click [Start] on the taskbar, point to [Control Panel], and then click [Network
and Internet Connections]
and Internet Connections]
.
BBBB
Click [Local Area Connection]. On the [General] tab, click [Properties].
Note
❒ With the IP over 1394, click [1394 Connection].
CCCC
Make sure that the“Internet Protocol (TCP/IP)” is selected in the [This con-
nection uses the following items:]
nection uses the following items:]
box on the [General] tab.
Note
❒ Select the TCP/IP protocol box if it is not already selected.
❒ If the TCP/IP protocol is not installed, click [Install...] on the [General] tab to
❒ If the TCP/IP protocol is not installed, click [Install...] on the [General] tab to
install it. For more information about installing the TCP/IP protocol, see
Windows XP/Server 2003 Help.
Windows XP/Server 2003 Help.
DDDD
Configure the TCP/IP protocol with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.
mask and other settings.
Check with the network administrator that the settings are correct.