Ricoh AP400 ユーザーガイド

Configuring the Protocols

Configuring a Windows NT computer

These steps are for configuring a Windows NT computer to use the TCP/IP pro-
tocol.

AAAA

Open [Control Panel], and then double-click the [Network] icon. Make sure
that “TCP/IP Protocol” is listed in the [Network protocols] box on the [Proto-
cols]

tab.

Note

❒ If the TCP/IP protocol is not installed, click [Add] on the [Protocols] tab to

install it. For more information about installing the TCP/IP protocol, see
Windows NT Help.

BBBB

Configure the TCP/IP protocols with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.

CCCC

Click the [Services] tab, and then make sure that “Microsoft TCP/IP Print-
ing” is installed.
If “Microsoft TCP/IP Printing” is not installed, click [Add] on the [Services ]
tab, to install it. For more information about installing and configuring net-
work services, see Windows NT Help.

Configuring NetBEUI for Printing

These instructions are for configuring the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.

Preparation
To use NetBEUI, use the SmartNetMonitor for Client port.

Configuring the machine

Configure the machine to use the NetBEUI protocol.
• Make sure that the NetBEUI protocol is set to active. (The default is active.)

Reference
For more information about how to make the above settings, see the Setup
Guide.