Ricoh AP400 ユーザーガイド
Windows NT 4.0 Configuration
58
4
Configuring LPR Port Printing
This section explains the procedure for printing to a LPR port from Windows
NT.
NT.
Note
❒ The following procedure assumes that the printer drivers have already been
installed. This is the procedure to change the printer port to LPR.
❒ The TCP/IP protocols must be installed and configured correctly. For more
information about configuring the protocol, see p.50 “Configuring TCP/IP
and IPP for Printing”.
and IPP for Printing”.
AAAA
Click [Start], point to [Settings], and then click [Printers].
BBBB
Click the icon of the printer you want to use. On the [File] menu, click [Prop-
erties]
erties]
.
CCCC
Click the [Ports] tab, and then click [Add Port].
DDDD
In the [Available Printer Ports] box, click “LPR Port”, and then click [New Port].
Note
❒ If “LPR Port” does not appear, “Microsoft TCP/IP Printing” has not been
installed.
EEEE
Type the IP address of the Network Interface Board into the [Name or address
of server providing lpd]
of server providing lpd]
box.
FFFF
Type “lp” into the [Name of printer or print queue on that server] box, and then
click [OK].
click [OK].
GGGG
Click [Close].
HHHH
Make sure that the port name is displayed in the [Print to the following port(s)]
box and the check box is selected, and then click [OK].
box and the check box is selected, and then click [OK].