Ricoh AP400 インストールガイド

ページ / 96
Bluetooth Interface Unit Type 2045
39
2
Bluetooth Interface Unit Type 2045
Note
❒ Depending on the model you use,
the Network Interface Board , the
1394 Interface Unit, 802.11b Inter-
face Unit, and the Bluetooth Inter-
face Unit cannot be installed to the
printer at the same time. For more
information, see p.17 “Installing
Options”.
Important
❒ Before touching the Bluetooth In-
terface Unit, touch something met-
a l   t o   d i s c h a r g e   a n y   s t a t i c
electricity. Static electricity can
damage the Bluetooth Interface
Unit.
❒ Do not subject the Bluetooth inter-
face unit to physical shocks.
Limitation
❒ You must install additional Memo-
ry Units to use the Bluetooth Inter-
face Unit. See p.24 “Memory Unit
Type C (SDRAM Module)”
AAAA
Check the contents of the box for
the following items:
• Bluetooth Interface Unit
• Card
• Antenna Cap
• Installation Guide
BBBB
Confirm that the followings are
true:
• The power switch is turned off.
• The interface cable is unplugged
from the printer.
CCCC
Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ These screws are used again in
step 
DDDD
Pull out the handle of the control-
ler board.
ZKEX750E
ZKEX370E