Frigidaire gleq2152ee インストール手順

 

Figure 1              

1.Open door and remove four (4) plugs in the door opening 
opposite the hinges. Retain all parts for uses later, unless 
otherwise noted. (Figure 1) Note: Use care in removing plugs 
in not scratching paint on the front panel. 

 

2. Begin removing the four (4) screws that attach the hinge to      
the front panel. (Figure 2) For best results, start by only 
removing one screw per hinge. Then only loosen the two 
remaining screws while firmly holding door to prevent damage 
to hinge, front panel or door. After the remaining screws are 
loosened, continue to remove all. 

         

 

3. Place door on a towel or pad handle side down to prevent 
any possible scratches to door. Remove all remaining four (4) 
screws between hinge and door. (Figure 3) 

 
 
   
       
 
  

 

     

 

                          

4. Remove two (2) door handle screws and two (2) hole plugs 
from door. Again taking care not to scratch paint on door. 
(Figure 4) 

 

5. Pull handle away from door assembley. (Figure 5) 
6. Install two (2) hole plugs from step 4 into holes that door 
handle screws were just removed.   

 

 Figure 6 

7. Flip door so lens side is facing up. Apply moderate pressure 
downward and rotate lens 180 degrees so that holes in lens 
align with transition ring plugs. (Figure 6) 

(Only required on 

doors with transition plugs).