Frigidaire fas296p2a1 インストール手順

NOTE:  Windows  come  in  a  variety  of different 
styles.  Therefore,  it may  be necessary to modify
or improve  your particular installation.

A.  Attach  the  bracket  assembly to 90 angle 
support brackets (Fig. 5) using (2) 1/4”X1      ”  
bolts two bolts per bracket. Secure with the (2) 
1/4"  lock  washers and (2) 1/4"nuts. DO NOT 
immediately  tighten  these  bolts  as it  may be 
necessary  to adjust  the  depth of  the bracket 
assembly,  depending  on  the  depth  of   your
window sill. See (Fig. 6).Install the two leveling 
screws  into  the 90  support brackets. Test the 
bracket assembly in the window before cabinet 
installation. If the leveling screws are distanced 
too far away from the wall to provide stability, it 
may be necessary for you to shim this area with 
a solid piece of wood. See (Fig. 7).  

Fig. 5

Bracket Assembly

Bracket Bolts

Leveling Screw

V-slot

90  Angle
Support Brackets

(TOP VIEW)

12 3/5" 

Center

Window sill

V-slot

(2) 3/4" screws per bracket

Bracket Assembly

Leveling Screw

Outer Wall Construction

3/16" Maximum

C. Measure  the  inside  window  sill  width  and 
find   the   center   as   shown  in   (Fig. 8),  and 
measure  12 3/5"  either  side  of the center line. 
Align the V-slot in each bracket on these marks 
and   mount  the  brackets  to the sill using  3/4" 
screws     provided.     Brackets     should     be 
perpendicular to the inside window sill. 
See (Fig. 8).

B. For  proper  condensation  run-off  it  will   be 
necessary   to   adjust  the   angle/pitch   of   the 
window   brackets.  This   is   accomplished   by 
adjusting  the  distance of the leveling screw on 
the outer wall. The maximum angle/pitch 
should not exceed more than 3/16". See (Fig.6).

Use a solid piece of wood to provide stability. This
will be required when sills are extra deep. 

See (Fig. 8).

Window Sash

Window Sash
Sealing Strip

Solid Piece Wood
(If required)

Fig. 8

Fig. 6

Fig. 7

Fig. 9

12 3/5" 

D. Cut the sash seal to  fit the underside of the 
bottom  window  sash.  Remove  the   peel-off 
backing  on  the  foam and attach it to this sash. 
See (Fig. 9).

 5

1

2