Frigidaire fas296p2a1 ユーザーガイド

4

The  power  supply cord with 

this   air   conditioner   contains  a   current 
detection  device  designed to  reduce  the 
risk of fire.
Please  refer to  the  section ‘Operation  of
Current Device’ for details.
In the event that the  power  supply cord  is 
damaged, it cannot be  repaired it  must be 
replaced   with  a  cord  from   the   Product 
Manufacturer.

                             For Your Safety                              
Do  not  store  or  use  gasoline or other flammable vapors and liquids in 
the  vicinity of   this  or  any  other  appliance.  Read  product  labels  for 
flammability and other warnings.

                             Prevent Accidents  
To  reduce  the  risk  of  fire,  electrical  shock, or injury to persons when 
using   your   air  conditioner,  follow  basic  precautions,   including  the 
following:

Be  sure  the  electrical  service  is  adequate  for  the  model you have 

    chosen.  This  information  can be  found  on the  serial plate, which is 
    located on the side of the cabinet and behind the grille.

If  the air conditioner is to be  installed in a  window, you  will  probably 

   want to clean both sides of the glass first. If the window is a triple-track 
    type  with  a  screen  panel  included,  remove  the  screen completely 
    before installation.

Be  sure  the  air conditioner has been securely and correctly installed 

    according  to the separate  installation instructions provided with this 
    manual.  Save  this   manual   and   the   installation   instructions   for 
    possible  future use in removing or reinstalling this unit.

When handling the air conditioner, be careful to avoid cuts from sharp 

    metal fins on front and rear coils.

                              Electrical Information 
The complete electrical rating of your new room air conditioner is stated 
on  the  serial  plate.  Refer  to  the  rating  when  checking the  electrical 
requirements.

Be  sure  the  air  conditioner is properly grounded. To minimize shock 

    and  fire  hazards,  proper  grounding  is  important. The power cord is 
    equipped  with  a three-prong  grounding  plug  and  a current leakage 
    detection device for protection against shock & firehazards.

Your  air   conditioner  must  be   used  in  a   properly   grounded   wall 

    receptacle. If  the wall  receptacle you intend to use is not adequately 
    grounded  or protected  by a time delay fuse or circuit breaker, have a 
    qualified electrician install the proper receptacle.

Do not run air  conditioner with  outside protective cover in place. This 

    could result in mechanical damage within the air conditioner.

 

The  capacity  of  the  room  air  conditioner  must  fit  the  room size  for 

    efficient and satisfactory operation.

Install   the  room  air  conditioner  on  the  shady  side of your  home.  A 

    window that faces north is best because  it  is  shaded  most of  the day.

Close  the  fireplace  damper,  floor and wall registers  so cool air  does 

    not escape up the chimney and into the duct work.

Keep  blinds  and  drapes  in other  windows closed during the sunniest 

    part of the day.

Clean the air filter as recommended in the section “Care and Cleaning”
Proper  insulation  and  weather stripping in  your  home  will  help keep 

    warm air out and cool air in.

External house shading with trees, plants or  awnings  will help  reduce 

    the air conditioner work load.

Operate  heat  producing  appliances  such as ranges, washers, dryers 

    and dishwashers during the coolest part of the day.

!

!

!

!

                               Avoid     fire   hazard    or 
electric  shock.  Do  not use  an  extension 
cord or  an  adaptor  plug.  Do  not  remove 
any  prong  from  the  power  cord.

!