Frigidaire DGGF3054KF ユーザーガイド

28

• Control panel

• Decorative trim (some models)

• Oven interior (see Self-Cleaning section)
• Keep Warm Drawer porcelain surfaces
• Porcelain enamel broil pan &

broil pan insert (if equipped)

• Door liner & porcelain enamel parts

• Control knobs

• Painted body parts

• Painted decorative trim

• Aluminum (trim pieces) & vinyl

• Easy Care™ Stainless Steel

(some models)

• Oven racks

• Oven door exterior surfaces

self-clean cycle. Clean using a mild, abrasive cleaner following the

manufacturer's instructions. Rinse with clean water and let dry.

Use soap & water to thoroughly clean the top, sides and front of the

oven door. Rinse well. You may use a glass cleaner on the outside

glass of the oven door. Do not immerse the door in water. Do not

vents. Do not use oven cleaners, cleaning powders or any harsh

abrasive cleaning materials on the outside of the oven door. Do not

clean the oven door gasket. On self-cleaning models the oven door

gasket is made of glass woven material which is essential for a good

seal. Care should be taken not to rub, damage or remove this gasket.

See Cleaning the cooktop and surface burners instructions provided in

the following Care & Cleaning section.

• Cooktop surface and contoured well

For general cleaning, use hot, soapy water and a cloth. For more

difficult soils and built-up grease, apply a liquid detergent directly

onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp

cloth and dry. Do not use abrasive cleaners on any of these

materials; they can scratch. To remove control knobs, turn to the OFF

position; grasp firmly and pull straight off the shaft. To replace knobs

after cleaning, line up the flat sides of both the knob and the shaft;

then push the knob into place.

Before cleaning the control panel, turn all controls OFF and if needed

remove any knobs from the panel. Clean using hot, soapy water and

a dishcloth.  Be sure to squeeze excess water from the dishcloth

before wiping the control panel; especially when wiping around

the controls area. Excess water in or around the controls may cause

damage to the appliance. When rinsing, use clean water and a

dishcloth and be sure to squeeze excess water from dishcloth before

wiping the control panel.

If your range finish is Easy Care™ Stainless Steel (some models),

clean the coated surface with warm soapy water using a clean sponge

or cloth. Rinse with clean water and dry with a soft clean cloth. DO

NOT use ANY store bought cleaners like Stainless Steel cleaners or

any other types of cleaners containing any abrasives, chlorides,

chlorine or ammonia. It is recommended to use mild dish soap and

water or a 50/50 solution of water and vinegar.

Gentle scouring with a soapy non-abrasive scouring pad will remove

most spots. Rinse with a 1:1 solution of clear water and ammonia. 

If

necessary, cover difficult spots with an ammonia-soaked paper towel

for 30 to 40 minutes. Rinse with clean water and a damp cloth, and

then scrub with a soap-filled non-abrasive scouring pad. Rinse and

wipe dry with a clean cloth. Remove all cleaners or the porcelain may

become damaged during future heating.