Frigidaire glcs378dsa ユーザーガイド

The Burner Grates, Burner Caps and Burner Heads should be routinely
cleaned. Keeping the burner ports clean will prevent improper ignition
and an uneven flame at each burner position. Refer to the following
instructions:

To Remove and Replace the Surface Burner Grate, Surface Burner
Cap and Surface Burner Head  -  Remove in the following order; (1st)
Surface Burner Grate, (2nd) Surface Burner Cap, (3rd) Surface Burner
Head (See Figure 1).

Reverse the procedure above to replace the Surface Burner Cap, Surface
Burner Head and Surface Burner Grate. Do not remove any burner
parts from the cooktop until the burner parts have completely
cooled and are safe to handle. Do not operate the surface burners
without the Surface Burner Caps, Surface Burner Heads and
Surface Burner Grates properly in place.

To Clean the Burner Caps, Burner Heads and Grates- Use a soap-filled
scouring pad or a mild abrasive cleanser to clean the surface burner caps
and surface burner heads. The Grates are designed to be Dishwasher safe
for cleaning. The ports (or slots) around the burner heads must be
routinely cleaned. If residue still remains in these ports, use a small-gauge
wire or needle to clean the slots or holes. For proper flow of gas and
ignition of the burner—DO NOT ALLOW SPILLS, FOOD, CLEANING
AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE
HOLDER OPENING. ALWAYS keep the surface burner cap and surface
burner head in place whenever a surface burner is in use.

 Use caution when replacing the burner cap so the electrode is not damaged. This may cause a delayed ignition

or prevent the burner from igniting.

 Any additions, changes or conversions required in order for this appliance to perform satisfactorily must be

made by an authorized servicer.

THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.

Figure 1

Orifice
holder

Electrode

Surface

Burner

Head

Surface

Burner

Cap

Surface

Burner

Grate

Cap Pilot Hole

Grate Pin