Frigidaire frs26zxhw2 ユーザーガイド

3

This Owner’s Guide provides specific operating instructions for your model. Use
refrigerator only as instructed in this Owner’s Guide.  Before starting refrigerator,
follow these important first steps:

Install refrigerator:

• near a grounded electrical outlet. DO NOT use an extension cord or an adapter plug.
• out of direct sunlight and away from range, dishwasher, or other heat sources,

if possible.

• on a floor that is level and strong enough to support a fully loaded refrigerator.
• where a water supply is available for automatic ice maker.

• Do not install refrigerator where temperature will drop below 60°F (15°C), or

rise above 110°F (43°C).  Compressor will not be able to maintain proper
temperatures.

• In a recessed installation, allow an extra 1/2 inch (10-15 mm) on each side for

ease of installation.

• If the hinge side of the unit will be placed against a wall, allow a 1-3/4 inch (44

mm) space between wall and refrigerator to permit proper door swing.

For best use of drawers and freezer basket, refrigerator should be in a position
where both the refrigerator and freezer doors can be opened about 135°.

• Refrigerator must be leveled with all bottom corners resting firmly on a solid

floor. Adjust front rollers to level cabinet both front-to-rear and side-to-side.
Keep cabinet as low as possible for stability.  Never adjust cabinet rollers so front
is lower than rear.

• To adjust front rollers:  Open refrigerator and freezer doors. Remove toe grille

by pulling it straight out. Adjust rollers by turning each roller adjusting bolt with
an adjustable wrench, a socket wrench, or a nutdriver until  refrigerator is level
and stable. Rear rollers are not adjustable.

• Check both doors to be sure seals touch cabinet evenly on all four sides.
• If freezer door is higher than refrigerator door, raise right corner and/or lower left

corner until doors align across top of cabinet.

• If refrigerator door is higher than freezer door, raise left corner and/or lower right

corner until doors align across top of cabinet.

• To replace toe grille:  Line up tabs with holes, and push grille straight on.

• Wash the inside, all removable parts, and the outside with mild detergent and

warm water.

  

Wipe dry.  Do Not Use Harsh Cleaners On These Surfaces.

• Do Not use razor blades or other sharp instruments that can scratch appliance

surface, when removing adhesive labels. Any glue left from the tape or energy
label can be removed with a mixture of warm water and mild detergent, or touch
glue with sticky side of tape already removed.

• Do Not Remove Serial Plate.

Adjusting Front Rollers

ROLLER ADJUSTING

BOLT

Replacing Toe Grille

• Never unplug the refrigerator by pulling on the power cord. Always grip the plug

firmly, and pull straight out from the receptacle.

• To avoid electrical shock, unplug the refrigerator before cleaning and before

replacing a light bulb.  NOTE: Turning the control to OFF turns off the compressor,
but does not disconnect power to the light bulb or other electrical components.

• Do not operate the refrigerator in the presence of explosive fumes.
• Avoid contact with any moving parts of the automatic ice maker.