Frigidaire frt22inlhc1 ユーザーガイド

3

This Owner’s Guide provides specific operating instructions for your model. Use the
refrigerator only as instructed in this Owner’s Guide. Before starting the refrigerator,
follow these important first steps.

• Choose a place that is near a grounded electrical outlet. Do Not use an

extension cord or an adapter plug.

• If possible, place the refrigerator out of direct sunlight and away from the

range, dishwasher or other heat sources.

• The refrigerator must be installed on a floor that is level and strong enough to

support a fully loaded refrigerator.

• Consider water supply availability for models equipped with an automatic ice

maker.

• Do not install the refrigerator where temperature will drop below 60°F (15°C)

or rise above 110°F (43°C).The compressor will not be able to maintain proper
temperatures.

• Allow space around the unit for good air circulation. Leave a 1 inch (25 mm)

space behind and a 3 inch (75 mm) space above the refrigerator for adequate
circulation.

• In a recessed installation, allow an extra 1/2 inch (10-15 mm) on each side, for

ease of installation.

• For best circulation, elevate the unit 1 inch (25 mm) from the floor, especially

if the floor is carpeted.

The doors should open to allow easy access to a counter when removing food.
• Do not position the refrigerator so you have to walk around the refrigerator

doors.

• Reverse the doors, if necessary. See Door Reversal Instructions.

All four corners of refrigerator must rest firmly on a solid floor.

To adjust front rollers:
1. Open refrigerator door and remove Toe Grille. (Figure 1)

2. Use an adjustable wrench to adjust rollers. (Figure 2)

3. Turn Roller Adjusting Bolt clockwise to raise and counter-clockwise to lower.

Raise the front of cabinet enough so doors will close freely when opened
halfway.

4. Level cabinet side to side.

5. Replace Toe Grille. (Figure 1)

• Wash the inside, all removable parts, and the outside with mild detergent and

warm water.  Wipe dry.  Do Not use harsh cleaners on these surfaces.

• Do not use razor blades or other sharp instruments that can scratch appliance

surface, when removing adhesive labels. Any glue left from tape or energy
label can be removed with a mixture of warm water and mild detergent, or
touch  residue with sticky side of tape already removed.

• Do not remove the Serial Plate.

To Remove Toe grille: Grip sides of Toe
Grille and pull straight off.
To Replace Toe Grille: Line up clips with
holes and push straight on.

Replacing Toe Grille

(Figure 1)

(Figure 2)