Frigidaire frt22rrhw3 ユーザーガイド

ページ / 18
13
Freezer control is set too warm. Set the freezer control to a colder setting until the freezer temperature
is satisfactory. Allow 24 hours for the temperature to stabilize.
Refrigerator control is set too warm.  Refrigerator control has some effect on freezer temperature.
Set the refrigerator control to a colder setting. Allow 24 hours for the temperature to stabilize. Then, if
the freezer temperature is not right, set the freezer control to a warmer setting. Refer to Setting the
Controls.
Chilled Air Control is set too warm. Adjust the Chilled Air Control to a colder setting.
Weather is hot and humid which increases rate of frost buildup and internal sweating. This is normal.
Door is slightly open. See Occurrence section 
OPENING
/
CLOSING
 
OF
 
DOORS
/
DRAWERS
.
Door is opened too often or too long. Open the door less often.
Vegetables contain and give off moisture. It is not unusual to have moisture on the bottom side of the
cover.
Washed vegetables and fruits drain while in the drawer. Dry items before putting them into drawer.
Water collecting in bottom of drawer is normal.
Weather is humid. This is normal in humid weather. When humidity is lower, the moisture should
disappear. Set Energy Saver switch to the Reduce Exterior Moisture position.
Door is slightly open, causing cold air from inside the refrigerator to meet warm air from outside. See
Occurrence section 
OPENING
/
CLOSING
 
OF
 
DOORS
/
DRAWERS
.
Ice maker wire signal arm is in "up" or OFF position. Move wire signal arm to "down" or ON  position.
Household water line valve is not open. Turn on household water line valve.
Water supply valve in refrigerator is being blocked by foreign material. Unplug the refrigerator and turn
off water supply. Slide refrigerator out and locate where water is connected to the valve. Unscrew the
brass fitting and pull out the screen from inside the valve mesh. Clean the screen of foreign material.
Replace screen and brass fitting and turn the water supply on; check for leaks. Plug in refrigerator and
slide into place.
Freezer is not cold enough. See Occurrence section 
TEMPERATURES
 
ARE
 
TOO
 
WARM
.
Saddle valve on cold water pipe is blocked or restricted by foreign material. Turn off household water
line valve. Remove, clean or replace valve.
Ice maker is producing less ice than you expect. Ice maker should produce approximately
2 1/2 to 4 pounds of ice every 24 hours.
Freezer is not cold enough. See Occurrence section 
TEMPERATURES
 
ARE
 
TOO
 
WARM
.
Household water line valve is not completely open. Turn on household water line valve.
Water supply valve in refrigerator is being blocked by foreign material. See Occurrence, "Ice maker
is not making any ice" 
above.
Ice cubes are not being used frequently enough. Remove and shake ice bucket to separate cubes.
Ice has picked up odor or flavor from strong food stored in refrigerator or freezer. Cover foods tightly.
Discard stale ice. Ice maker will produce fresh supply.
Water running to ice maker has poor taste or odor. Add filter to ice maker. Consult a water purifying
company.
Temperature in the freezer is too warm.
Temperature in the refrigerator is too warm
and the freezer temperature is satisfactory.
Temperature in the Meat Keeper (some mod-
els) is too warm.
SOLUTION
TEMPERATURES ARE TOO WARM
Moisture collects on inside of refrigerator
walls.
Water collects on bottom side of drawer
cover.
Water collects in bottom of drawer.
Moisture forms on outside of refrigerator or
between doors.
Ice maker is not making any ice.
AUTOMATIC ICE MAKER (some models)
Ice maker is not making enough ice.
Ice maker is not separating the cubes.
Ice has bad odor and taste.
OCCURRENCE
WATER/MOISTURE/FROST INSIDE REFRIGERATOR
WATER/MOISTURE/FROST OUTSIDE REFRIGERATOR