Frigidaire FGHB2844LF オーナーマニュアル

10

Be sure doors are set aside in a secure position where 

they cannot fall and cause personal injury, or damage 

to the doors or handles.  

Once both doors are in place, ensure they are aligned 

with each other and level (Please see the “Installation” 

section for more details), and replace the top hinge cover.

  4  Unscrew the three (3) lower hinge screws and 

hinge if necessary.

To reinstall the right door, reverse the above steps.

removing Freezer Drawer
  1  Open freezer drawer.
  2  Remove drawer screws on right and left sides (two 

(2) screws on each side).

  3  Lift drawer up and out to remove.

Installing Freezer Drawer
  1  With lower slides pulled out, hang drawer onto 

slide brackets ensuring pins on each side are fully 

inserted into slots on each side.

  6  Tighten four (4) drawer screws.
  7  Recheck gasket seal.
  8  Install the toe grille by fitting into place.

  2  Reinstall four (4) drawer screws (two (2) per side), 

tighten down, and close drawer (C).

Pull Drawer Out

From Both Sides

Grab Drawer

At Center

Then

Push Against

Freezer Drawer

Fully Extend  

Assembly

 

Drawer Slides

Pin

Slot

Cabinet

Drawer

Install Screws

(2) Each Side

  3  Check gasket seal around top, bottom, and sides of 

freezer drawer.

  4  If gasket is not sealed, open drawer and slightly 

loosen four (4) drawer screws (two (2) on each 

side) to allow drawer to rotate.

  5  Close drawer and recheck the seal on the gasket 

(A).  Open the drawer grabbing by the sides in the 

center (B).  Be careful not to rotate the drawer.



You will be pulling approximately three (3) feet of 

water tube from the back of the refrigerator.



DO NOT remove center screw from freezer drawer.  

This is a factory adjustment.