Frigidaire FGHG2344M ユーザーガイド

22

Your refrigerator is equipped with water filtering system.

The water filter system filters all dispensed drinking

water, as well as the water used to produce ice.

The water filter is located at the top right side of the

fresh food compartment. 

To order your replacement filters, please visit our online

store at www.frigidaire.com/store, by calling toll-free 

at 877-808-4195, or by visiting the dealer where you 

purchased your refrigerator. Frigidaire recommends 

that you order extra filters when you first install your

refrigerator, and that you replace your filters at least once

every six months. 
Here is the product number to request when ordering: 
  PureSource Ultra

TM 

Water Filter

  Part #ULTRAWF

In general, you should change the water filter every six

months to ensure the highest possible water quality. The 

Water Filter Status light on the user interface prompts 

you to replace the filter after a standard amount of water

(200 gallons/757 liters for PureSource Ultra

TM

)

 

has 

flowed through the system. The water filter status light

on this model is not performance tested or certified by

NSF.
If your refrigerator has not been used for a period of time 

(during moving for example), change the filter before

reinstalling the refrigerator.

Do not use with water that is microbiologically unsafe or 

of unknown quality without adequate disinfection before 

or after the system. Systems certified for cyst reduction

may be used on disinfected waters that may contain 

filterable cysts.

 •  Rated Capacity - 200 gallons/757 liters for

TM

ice and water filter

 •  Rated service flow - .50 gallons per minute
 •  Operating Temp.: Min. 33°F, Max. 100°F
 •  Maximum Rated Pressure - 100 pounds per square

inch

 •  Recommended Minimum Operating Pressure: 30

pounds per square inch

TM

It is not necessary to turn the water supply off to change 

the filter. Be ready to wipe up any small amounts of water

released during the filter replacement.
  1 Turn Off the ice maker by raising the wire signal 

arm.   

  2  Remove the filter by pushing on the end/face of the

filter.

  3  Slide the old water filter cartridge straight out of the

housing and discard it.

  4  Unpackage the new filter cartridge. Using the

alignment guide, slide it gently into the filter housing

until it stops against the snap-in connector at the 

back of the housing.

  5  Push firmly until the cartridge snaps into 

engages the snap-in connector). 

  6 Turn On the ice maker by lowering the wire signal 

arm.

  7  Press and hold the Water Filter

button on the Ice 

& Water Dispenser control panel for three seconds. 

When the display changes from Red to Green, the 

status has been reset.

  8  After replacing the water filter and in order for the

ice maker to work properly, it is necessary to clear 

air from water filter tubing. Once ice maker begins

making ice, allow the bucket to fill completely, then

discard the first TWO FULL buckets of ice. It will

take at least two days to completely fill the bucket

on regular ice making mode or 1 

1

/

2

 days on fast ice 

mode.

The PureSource Ultra

TM 

ice and water filter

system is tested and certified to NSF/ANSI

Standards 42 and 53 for the reduction of claims 

specified on the performance data sheet.