Microtek 1800f 補足マニュアル

3. Make sure that the FireWire card (IEEE 1394) is properly seated in your computer’s PCI slot.

a) Turn off your computer, then remove the cover.

b) Make sure the FireWire card is seated all the way in and secured into the PCI card slot. If the card is

not properly seated, REMOVE, and then REINSERT the FireWire card again.

c) Restart your computer.

Q2: The FireWire card (IEEE 1394) was found but my scanner cannot be detected by

Windows.

Follow the instructions below:

1. Turn off your scanner.

2. Make sure that only one FireWire cable is connected to your scanner. (You can only use one cable or

interface at a time).

3. Make sure to properly connect the scanner's FireWire cable to your computer, then plug the power

cord into a power source.

4. Turn on your scanner and wait until all lights on the front of the scanner to stop blinking and remain on

solid. Windows should now be able to automatically detect your scanner.

Q3: The FireWire card (IEEE 1394) was found but my scanner cannot be detected by

Windows 98 SE.

If you are currently using the FireWire interface on Windows 98 SE, you need to follow the instructions
below to reinstall FireWire driver.

1. Open the System Properties

System Properties

dialog box by clicking the
following in succession: Start

Start

Start,

Settings

Settings, Control Panel

Control Panel

Control Panel, and

then double-click the System

System

icon.

2. From the System Properties

System Properties

System Properties,

select the Device Manager

Device Manager

tab, then double-click [?]

[?]

IEEE 1394 SBP2 Device

IEEE 1394 SBP2 Device to
open the its Device

Device

properties

properties dialog box.

3. Click the Reinstall Driver

Reinstall Driver

button.