Optoma DE-GWII9106E 仕様ガイド

Unpack screen carefully, be sure screen is in good condition,

and check that all accessories are included inside carton.

Care in mounting and care in correct operation will mean a

long and satisfactory life for your Panoview screen. Locate the

screen where the audience can best see it and where other

furnishings in the room permit.

Check that voltage and frequency marked on screen is in

accordance with local power utility. It is suggested only to use

screen indoor under normal temperature and humidity

conditions.

Remove two pulling locks on the bottom slat bar after the

case has been installed.

Install screen brackets onto ceiling or wall with appropriate

hardware.

Anchor screen onto bracket as shown in above figure below.

MOUNT SCREEN TO WALL

MOUNT SCREEN TO CEILING

SCREEN ADJUSTMENT

Note: Adjustments to screen limit positions, can only

be performed by a trained technician.

Screen travel is stopped automatically in the down and up positions

by limit switches that are preset in the factory. If it is necessary to adjust

for more or less, please follow the steps below for adjustment.

Disconnect the power supply first before any operation.

Remove the plate on right bottom side of screen housing.

This is important.

Loosen Fasten Screw(F) first before adjustment,

Upper limit switch is on the left side and bottom limit is on the right

side.

Tighten Fasten Screen( F) after all adjustment.

PLATE

LEFT SCREW(LS)

RIGHT SCREW(RS)

FASTEN SCREW(F)