Lowrance 5200c 操作ガイド

 

128 

5. Highlight the desired Temp Type and press 

. The following con-

firmation message will appear: Are you sure you wish to change this 
device's configuration?  
6. Highlight 

 and press 

. Press 

 repeatedly to get back to the 

main display. 
Advanced Options menu 
The Temp sensor Advanced Options menu contains two categories: In-

stance and Restore Defaults.  

 

The Instance command is intended for use only by experienced NMEA 

2000 network technicians. Instance allows network technicians to re-

solve certain electronic probe conflicts. This is most likely to occur if the 

network includes LMF-200 or LMF-400 digital gauges, which support 

the display of fewer electronic probes than your GPS or sonar/GPS unit.  
If you want to use your unit in a network including one of these digital 

gauges, you may need to consult customer service. You should never 

need this command if you are connecting your unit to a network with 

similar display units and/or a series of electronic probes.  

The Restore Defaults command allows you to reset an individual EP-35 

Temp Sensor's settings to factory defaults. If, for example, you execute 

the Restore Defaults command from your Water Temp's Advanced Op-

tions menu, only the settings for the Water Temp will be reset to fac-

tory defaults. Other temps on the network will not be affected. 

1. Press 

, use 

↑ ↓  to select 

 and press 

. The 

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-

agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-

chronization.  
2. Highlight 

 and press 

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page. 
3. Select the desired temp sensor and press 

. The Device Configura-

tion menu will appear.  
4. Highlight 

 and press 

.  

5. Select 

 and press 

. The following message will 

appear: Are you sure you wish to change this device's configuration?  
6. Highlight 

 and press 

. Press 

 repeatedly to get back to the 

main display.