Lowrance lcx-112c 操作ガイド

 

148

The GPS simulator lets you use the unit as if you were navigating 
outdoors. It's a great way to practice using your unit. You can set the 

starting location from a stored waypoint, map place or POI location or by 
entering latitude and longitude. You can steer your position and change 

speed on the map by using the arrow keys (

 command) 

or by setting the track and speed in the dialog boxes provided on the 
simulator menu screen. 
To get to the GPS Simulator: 
1. Press 

|

|

↓ to 

|

. 

2. Press 

↓ to 

|

. The GPS Simulator Menu appears. 

 

 

Choose the desired settings, then turn the simulator on by highlighting 

the 

 box and pressing 

 key. Press 

|

|

 

to close this menu. A message and tone appear periodically, warning 
you the simulator is on. To turn off the simulator, repeat the above 

steps or turn off the unit. 
While in simulator mode and using the 

 command, you 

can press 

 to clear the steering and speed boxes from the screen. 

This will allow you to use the map cursor during a simulation. To turn 

steering and speed boxes back on again, return to the GPS Simulator 
menu. Select the 

 command, press 

then 

. 

Simulating Trail or Route Navigation 
In Simulator mode, your unit can automatically follow a trail or route 
without manual steering if you use these steps: 
1. From the Map Page, go to the simulator menu. Pick a 

 

at or near the beginning of your trail/route. Enter an approximate 

 

(shown in compass degrees) that will point you toward the start of the 

trail/route.