Lowrance lcx-112c 操作ガイド

 

15

 

 

A.  One-piece bracket: Slide the transducer between the two 

ratchets. Temporarily slide the bolt though the transducer assembly 
and hold it against the transom. Looking at the transducer from the 

side, check to see if it will adjust so that its face is parallel to the 
ground. If it does, then the "A" position is correct for your hull. 
If the transducer's face isn't parallel with the ground, remove the 

transducer and ratchets from the bracket. Place the ratchets into the 
holes in the bracket with the letter "B" aligned with the dot stamped 

in the bracket. 
Reassemble the transducer and bracket and place them against the 
transom. Again, check to see if you can move the transducer so it's 

parallel with the ground. If you can, then go to step 3A. If it doesn't, 

repeat step 2A, but use a different alignment letter until you can 
place the transducer on the transom correctly.