Lowrance lcx-112c 操作ガイド

 

86

Situations occur, however, when it becomes necessary to increase or 

decrease sensitivity. This typically happens when you wish to see more 
detail, so an increase in sensitivity is needed. Or when wave action and 

boat wakes create tiny air bubbles that clutter much of the water 

column. In that case, a decrease in sensitivity is necessary to reduce 
some of the clutter. 
The control bar used to adjust sensitivity up or down is the same 

whether the unit is in the automatic or manual mode. In automatic, you 
can adjust sensitivity up to 100 percent but the unit will limit your 

minimum setting. In auto, the unit will continue to make small 

adjustments, allowing for the setting you selected. 
In manual mode, you have complete control over sensitivity, with the 
ability to set it anywhere from zero to 100 percent. Once you select a 

level in manual, the unit will continue to use that exact sensitivity 
setting until you change it or revert to auto mode. 
To adjust sensitivity in auto mode: 
1. Press 

|

. 

2. The Sensitivity Control Bar appears. Press 

↓ to decrease sensitivity; 

press 

↑ to increase sensitivity. When it's set at the desired level, press 

. (When you reach the maximum or minimum limit, a tone sounds.) 

 

 

To adjust sensitivity in manual mode: 
1. First, turn off Auto Sensitivity: from the Sonar Page. Press 

|

↓ 

to 

|

. 

2. Press 

↑ to 

|

 and the Sensitivity Control Bar appears. 

Press 

↓ or ↑ to pick a different sensitivity setting. When it's set at the 

desired level, press 

.