Lowrance lmf-400 ユーザーズマニュアル

20

NOTE:

If you configure the desired sensors and are not satisfied with the
results, you may clear the configuration settings for each sensor
individually, by resetting values from the sensor's configuration
menu. Remember, ONLY the sensor you select from the Bus
Devices list will be set back to its defaults. To reset the LMF-400 to
its defaults, you must select 

from the System Setup

Menu. We'll take a closer look at the 

 command later in

this section.

To get to the configuration menu:

1. Press 

, select 

 and press 

.

2. Highlight 

and press

 After a few moments, items

detected in the network will be listed. Use the 

 and 

 keys to

scroll through the list.

3. To configure an item in the list, highlight the item and press 

.

Temperature Sensors
When temperature sensors are selected from the Bus Devices menu,
the temp sensor configuration menu comes up with two choices:

 or 

.

To Unconfigure a temp sensor:
1. After selecting a temp sensor from the Bus Devices list and pressing

, choose 

 from the configuration menu and press

. The following message will appear: Hit Menu to UnCfg Temp

Sns.

2. Press 

  to unconfigure the sensor and be directed back to the

Bus Devices list.

To Configure a temp sensor:
1. If you highlight 

 and press 

, a window will pop up

asking if you want to configure the sensor.

2. Press 

 to be taken to the Selecting Temp menu.

3. Highlight one of the Temp options (Temp1, Temp 2, Temp 3, etc.) on
the Selecting Temp menu and press 

. The UnCfg temp now has

been configured as the Temp you selected. You automatically will be
redirected to the Bus Devices list.

To Reconfigure a temp sensor:
If you want to reconfigure a sensor, but all the sensors linked to the
LowranceNET are already configured, you must first unconfigure a
sensor, so its name will be available. Otherwise a Name Already
Selected message will appear.