Lowrance lms-334c igps 操作ガイド

25

Shoot-thru-hull transducer locations for

high speed or trolling speed operation.

To choose the proper location for shoot-thru-hull mounting, follow these
testing procedures: (You may need a helper to complete these steps.)

1. Anchor the boat in about 30 feet of water. Add a little water to the

sump of the boat. Plug the transducer into the sonar unit, turn it on,
then hold the transducer over the side of the boat in the water. Adjust
the sensitivity and range controls until a second bottom echo is seen on
the display. (You'll need to turn off Auto Sensitivity, Auto Depth Range
and ASP

. Try a range setting that is two to three times the water

depth. The harder (more rocky) the bottom, the easier it will be to get a
second bottom signal.) Don't touch the controls once they've been set.

Example of a second bottom signal. Unit is in 30 feet of water with

range set at 80 feet and sensitivity set at 87 percent.

2. Next, take the transducer out of the water and place it in the water

in the sump of the boat, face down. Notice how the signal strength
decreases. The second bottom signal will probably disappear and the
bottom signal intensity will likely decrease.