Lowrance lms-334c igps 操作ガイド

ページ / 204
37
Drill a 1-inch (25.4 mm) hole in the dash for the power and transducer
cables. The best location for this hole is immediately under the gimbal
bracket location. This way, the bracket can be installed so that it covers
the hole, holds the cables in position and results in a neat installation.
Some customers prefer to mount the bracket to the side of the cable
hole. It's a matter of personal preference.
Front view (left) and side view (right) showing dimensions of the unit
when mounted on gimbal bracket.
Pass the power cable's bare-wire end down though the hole from the
top. If you want, you can fill in the hole around the cables with a good
marine sealant. (Some marine dealers stock cable hole covers to conceal
the opening.) No matter what type of installation you prefer, be sure to
leave enough slack in the cables to allow tilting or swiveling the unit. If
you choose to fill in the hole, be sure to position the cables against the
rear edge of the hole as you apply the fill material.
Before positioning the bracket, be sure to hold the cables against the
rear edge of the hole. Then, slide the bracket over the hole and butt the
rear of the bracket base firmly against the cables, pinning them in
place against the side of the hole. Finally, fasten the bracket to the
dash. Attach the unit to the gimbal bracket using the supplied gimbal
knobs and washers.
Millimeter
[Inch]
 23.4
 [0.92]
 72.9
 [2.87]
 137.9
 [5.43]
 56.9
 [2.24]
 157.9
 [6.22]
 173.9
 [6.85]