Lowrance lms-350a 操作ガイド
6
Surface Mounting - Without Access
If you don't have access to the back side of the mounting surface, use
the "cleats" supplied with the LMS-350A. (Note: This is assuming you
can "snake" the module's cable to a location that is accessable. A hole
will still need to be drilled in the mounting surface for the cable.) Using
the gasket as a template, mark and drill the 17 mm (11/16") hole for the
cable. Attach the cable to the module and drop the other end of the
cable through the gasket and down the hole. Place the module on the
gasket. Slide the "cleats" onto each end of the module and (using the
cleats as templates) mark four holes for 5 mm (#10) mounting screws.
Drill the holes, then replace the cleats on the module and fasten them to
the mounting surface with 5 mm (#10) screws. Route the cable to the
LMS-350A.
If you don't have access to the back side of the mounting surface, use
the "cleats" supplied with the LMS-350A. (Note: This is assuming you
can "snake" the module's cable to a location that is accessable. A hole
will still need to be drilled in the mounting surface for the cable.) Using
the gasket as a template, mark and drill the 17 mm (11/16") hole for the
cable. Attach the cable to the module and drop the other end of the
cable through the gasket and down the hole. Place the module on the
gasket. Slide the "cleats" onto each end of the module and (using the
cleats as templates) mark four holes for 5 mm (#10) mounting screws.
Drill the holes, then replace the cleats on the module and fasten them to
the mounting surface with 5 mm (#10) screws. Route the cable to the
LMS-350A.
12345678901234567890123456789012123456789012345678901234
12345678901234567890123456789012123456789012345678901234
12345678901234567890123456789012123456789012345678901234
12345678901234567890123456789012123456789012345678901234
12345678901234567890123456789012123456789012345678901234
GASKET
CABLE
MARK AND
DRILL FOUR
PLACES
GPS MODULE
"CLEAT"
"CLEAT"