Lowrance lms-522c igps 操作ガイド

29 

Once you've determined the proper location for the unit, place the sen-

sor on the transom. The bottom of the bracket should be flush with the 

hull's bottom. Using the sensor as a template, mark the hull for the 

screws' pilot holes. Drill four 1/8" holes, one in each end of the slots. 

Mount the sensor to the hull using #8 stainless steel wood screws (not 
included). Use a high quality, marine grade above- or below-waterline 

sealant to seal the screws. Make sure the sensor is flush with the bot-

tom of the hull and tighten the screws. 

 

   

 

If the base of the transom has a radius, fill the gap between the tran-

som and the sensor with the sealant. This will help ensure a smooth 

water flow. 

Route the sensor's cable through or over the transom to the sonar unit. 

If you need to drill a hole in the transom to pass the connector through, 

the required hole size is 7/8".