Lowrance m52 s 操作ガイド

113

     

GPS Setup Menu, left; GPS Simulator menu, right.

Make the desired settings, then turn the simulator on by highlighting
the 

 box and pressing 

. Press 

|

|

 to

erase this menu. A message and tone appear periodically, warning you
that the simulator is on. To turn the simulator off, repeat the above
steps or turn the unit off.

While in simulator mode, you can press 

 to clear the steering and

speed boxes from the screen while continuing the simulation. This will
allow you to use the plotter cursor during a simulation. To turn steer-
ing and speed boxes back on again, return to the GPS Simulator menu,
select the 

 command, press 

, then Press

|

|

 to return to the previous page.

Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:

1. From the Plotter Page, go to the simulator menu. Pick a 

 at or near the beginning of your trail/route. Enter an approxi-

mate 

 (shown in compass degrees) that will point you toward the

start of the trail/route.

2. Set 

 to zero. Select 

 command and press 

,

which turns on the simulator and returns you to the Plotter Page.

3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press 

 to clear the alarm.) When navigation starts,

press 

↑ to increase speed to the desired setting.

4. Press 

 to turn off the steering and speed boxes. The unit will now

automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.