Lowrance mark-5x dsi ユーザーガイド
2
Mark and Elite Series Installation
This document covers the installation of the transducer and display unit
installation, which includes connecting the unit to power and installing the
unit on the bracket mount.
Transducer Installation
One piece bracket (Recommended Tools and Supplies — not included)
Drill
Marine grade above-or-below waterline sealant
1” (25mm) or 5/8” (15mm) drill bit
Marine grade epoxy (Shoot-thru-hull install only)
#29 (0.136”) (3mm) drill bit
Zip ties (trolling motor mount)
Phillips (Slotted-head) screwdriver
TMB-S bracket kit (Skimmer trolling motor mount)
NOTE: Make sure you read all the installation instructions before drilling holes
in your vessel. Check the transducer cable and power wires to make sure they will
reach the desired mounting location for the display unit. If they will not reach,
you either will have to select a different mounting location for the display unit, or
extend the transducer cable and /or power wires.
Installation