Lowrance x510c ユーザーズマニュアル

21 

sure that your selected location will work under all conditions, make a 

test run with the boat on plane and observe the bottom signal. You'll 

need to figure some way to prop the transducer into position while you 

make your test run. (A brick or two might be sufficient to hold it in 

place.) 

5. When you're satisfied with a location, mark it and proceed with 

the installation. 

Shoot-thru-hull Installation 
If you are installing the transducer on a hull with floatation material 

sandwiched within the hull, refer to the text "Hulls With Flotation Ma-

terials" beginning on page 18. 
1. Make sure the area is clean, dry and free of oil or grease, then sand 

both the inside surface of the hull and the face of the transducer with 

100 grit sandpaper. The sanded hull area should be about 1-1/2 times 

the diameter of the transducer. The surface of the hull must be flat 

so the entire transducer face is in contact with the hull prior to bond-

ing. After sanding, clean the hull and transducer with rubbing alco-

hol to remove any sanding debris. 

 

Use  only the epoxy available from LEI. It has been for-
mulated to work with these installation procedures. 
Other epoxy types may be too thin or may not cure to 
the right consistency for optimum transducer perform-
ance.