Lowrance x510c ユーザーズマニュアル

31 

 

 
After drilling the hole, pass the transducer connector up through the 
hole from under the dash. Pass the power cable's bare-wire end down 

though the hole from the top. 
If you wish, you can fill in the hole around the cables with a good ma-

rine caulking compound. (Some marine dealers stock cable hole covers 

to conceal the opening.) No matter what type of installation you prefer, 

be sure to leave enough slack in the cables to allow tilting or swiveling 

the unit. If you choose to fill in the hole, be sure to position the cables 

against the rear edge of the hole as you apply the fill material. 
Before positioning the bracket, be sure to hold the cables against the 

rear edge of the hole. Then, slide the bracket over the hole and butt the 

rear of the bracket base firmly against the cables, thus pinning them in 

place against the side of the hole. Finally, fasten the bracket to the 

dash. Attach the unit to the gimbal bracket using the supplied gimbal 

knobs and washers. 
In-Dash Installation 
You can mount the unit in the dash with an optional FM-5 In-Dash 

Adapter Kit. The kit includes mounting hardware, a template for cut-

ting the hole and an instruction sheet, part 988-0147-43.