Lowrance x510c ユーザーズマニュアル

66 

These faster ping rates allow you to maintain a high-detail picture on 

the screen, and the screen refresh rate and chart scroll speed can keep 

pace with the boat as it moves quickly over the bottom terrain. 
When using HyperScroll, you may also need to manually decrease the 

sensitivity for optimum performance. Depending on water depth and 

other conditions, HyperScroll may cause a second bottom echo to return 

to the transducer during the next ping cycle, or sounding. This can result 

in a large amount of clutter appearing on the screen. If this occurs, just 

decrease the sensitivity to a level that eliminates the clutter. When you 

turn HyperScroll off, you can return to your original sensitivity level. 

  

 

To change Ping Speed 
1. From the Sonar Page, press 

|

↓ to 

|

. 

2. The Ping Speed Control Bar appears. Press 

↑ to increase ping speed. 

Press 

↓ to decrease ping speed. When it's set at the desired level, press 

. 

To adjust Sensitivity 
1. From the Sonar Page, press 

|

. 

2. The Sensitivity Control Bar appears. Press 

↓ to decrease sensitivity; 

press 

↑ to increase sensitivity. When it's set at the desired level, press 

. (When you reach the maximum or minimum limit, a tone sounds.) 

To turn off HyperScroll 
1. From the Sonar Page, press 

|

↓ to 

|

. 

2. The Ping Speed Control Bar appears. Press 

↓ to decrease ping speed 

to 50 percent. When it's set at the desired level, press 

.