Rimage prism ユーザーガイド
Operating the Prism Printer
6. Select
the
Detect Media Change option.
•
If you are using a Rimage autoloader, select No.
•
If you are making multiple copies on a standalone Prism, select Yes.
Note: When the Detect Media Change option is enabled, you must press the operator
button after you remove the printed disc and place a new disc on the tray.
button after you remove the printed disc and place a new disc on the tray.
7. Disable
the
Perfect Print option. This option is only used for the Rimage AutoPrinter.
8. Select
the
Media Type.
9. To save the changes, select OK.
Print in color
1. Install a multicolor ribbon in the printer. Refer to Changing the print ribbon on page 14.
2. Navigate to printing properties. Refer to page 10.
3. Select
the
Device Settings tab.
4. Select
the
Installed Ribbon setting.
5. Select
Color, Three Panel CMY from the dropdown list.
Note: The Double Print selection is disabled when a color ribbon is selected because double print
is not available during the color printing process.
is not available during the color printing process.
6. Select
the
Media Type.
7. Select
the
Print Strobe setting and set the value from the table below.
Media Surface
Print strobe setting for multicolor ribbon
DVD or Regular
375 - 425
Thermal white overcoat
375 - 425
d to lower the
setting when trying to eliminate a halo effect on a printed
•
•
e operator
.
10.
nges that affect color intensity, color balance, or pattern settings, select Halftone Setup
. Select OK, to save the changes.
Note: This may require multiple test printings on discs to fine-tune the color hue. Set Enable Color
Sub-Strobes to Enabled to lower an individual color’s print strobe. For example, this setting can
be use
Sub-Strobes to Enabled to lower an individual color’s print strobe. For example, this setting can
be use
Yellow Print Strobe
disc.
8. Select
the
option:
Detect Media Change
If you are using a Rimage Producer system or an AutoPrinter, select
.
No
If you are making multiple copies on a standalone printer, select Yes.
Note: When the Detect Media Change option is enabled, you must press th
button after you remove the printed disc and place a new disc on the tray
button after you remove the printed disc and place a new disc on the tray
9. Disable
Perfect Print option. This option is only used for the Rimage AutoPrinter.
To make cha
Properties.
Properties.
11
110635_I
11