Amphony h2500 ユーザーガイド

User and Installation Guide

Page 5

R

R

Step 4

Step 4

After charging the batteries, insert them into the headphones.

There are two battery compartments, located on both sides, each housing one 
battery. To access each battery compartment, push on the outer edge of the 
battery lid. This will release the battery lid. Then lift the middle portion of the 
battery lid to gain access to the battery compartment.

Insert the battery by pressing the minus pole of the battery against the spring at 
the bottom of the battery compartment until the plus pole can slide into the battery 
compartment. The battery should snap into place.

Ensure that the plus pole of the battery properly contacts the battery contact 
inside the battery compartment to allow proper operation of the headphones. If 
necessary, rotate the battery inside the battery compartment until proper contact 
is established.

Finally, close the battery lid by pushing the middle section. It should snap into the 
closed position.

To remove the batteries, open the battery lid as described above and pull the 
battery out of the battery compartment by pushing the battery towards the bottom 
until the plus pole is released and slides out.

Push

1

2

3

Lift