Extreme 3802 インストールガイド
Installing a XENPAK Optical Transceiver Module
Extreme Networks Consolidated "i" and "e" Series Hardware Installation Guide
379
Figure 181: Installing the Summit XGM-2xn option card
5
Using the screws from the cover plate, secure the option card to the back panel of the switch.
6
Install the XENPAK optical transceiver modules as described in the next section, “Installing a
XENPAK Optical Transceiver Module”.
XENPAK Optical Transceiver Module”.
CAUTION
Be sure that the option slot always has either an installed Summit option card or a faceplate over the
opening. An opening could divert air from the switch and cause overheating.
opening. An opening could divert air from the switch and cause overheating.
Installing a XENPAK Optical Transceiver Module
This section describes installing and removing the XENPAK module, a 10 Gbps optical transceiver. The
LR XENPAK and the ER XENPAK look alike and install the same. An example of a XENPAK module is
shown in Figure 182.
LR XENPAK and the ER XENPAK look alike and install the same. An example of a XENPAK module is
shown in Figure 182.
Figure 182: XENPAK Modules
CAUTION
Use only Extreme-approved optic devices within Extreme switches. Optical modules provided by
Extreme Networks are compliant for use with Extreme systems.
Extreme Networks are compliant for use with Extreme systems.
ES4K042
Summit Option
Card
EWUG003C
Card edge
connector