Extreme 3802 ハードウェアマニュアル
Extreme Networks Consolidated Hardware Guide
287
18
Initial Switch and Management Access
This chapter describes:
•
•
Connecting Equipment to the Console Port
Connection to the console port is used for direct local management. The console port settings are:
• Baud rate
—9600
• Data bits
—8
• Stop bit
—1
• Parity
—None
• Flow control
—XON/XOFF
The terminal or PC with terminal-emulation software that you connect to any Summit, Alpine, or
BlackDiamond switch must be configured with these settings.This procedure is described in the
documentation supplied with the terminal.
BlackDiamond switch must be configured with these settings.This procedure is described in the
documentation supplied with the terminal.
Appropriate cables are available from your local supplier, or you can make your own. To ensure the
electromagnetic compatibility of the unit, only shielded serial cables should be used. Table 77 describes
the pinouts for a DB-9 male console connector.
electromagnetic compatibility of the unit, only shielded serial cables should be used. Table 77 describes
the pinouts for a DB-9 male console connector.
Table 77: Pinouts for the console connector
Function
Pin Number
Direction
DCD (data carrier detect)
1
In
RXD (receive data)
2
In
TXD (transmit data)
3
Out
DTR (data terminal ready)
4
Out
GND (ground)
5
-
DSR (data set ready)
6
In
RTS (request to send)
7
Out