Extreme 10808 インストールガイド
BlackDiamond 8810 AC Power Cord Retaining Bracket
Extreme Networks Consolidated XOS Hardware Installation Guide
144
Installing the BlackDiamond 8810 AC Power Cord
Retaining Bracket
Retaining Bracket
Follow these steps to ensure proper installation of the BlackDiamond 8810 AC power cord retaining
bracket:
bracket:
1
Ensure that all AC power cords are disconnected from the power source and from the power outlets
on front of the BlackDiamond 8810 chassis.
on front of the BlackDiamond 8810 chassis.
2
Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle located on the top-left corner of the
BlackDiamond 8810 chassis front panel.
the ESD-preventive wrist strap to the ground receptacle located on the top-left corner of the
BlackDiamond 8810 chassis front panel.
3
Loosen all captive screws, located in the middle and on each end of the BlackDiamond 8810 AC
power cord retaining bracket, using a #2 Phillips screwdriver as shown in
power cord retaining bracket, using a #2 Phillips screwdriver as shown in
Figure 83: BlackDiamond 8810 AC power cord retaining bracket
4
Remove the BlackDiamond 8810 AC power cord retaining bracket from the front of the
BlackDiamond 8810 chassis as shown in
BlackDiamond 8810 chassis as shown in
Figure 84: BlackDiamond 8810 AC power cord retaining bracket removed from the BlackDiamond
8810 chassis
8810 chassis
ASP011A
REMOVE TO INSTALL POWER CORDS
REMOVE TO INSTALL
POWER CORDS
ASP007