Intermec 5020 ユーザーガイド
Chapter 3 — CN3 Series, CK61, 700 Series, and CV30 Computers (Windows Mobile 5.0)
Data Collection Browser User’s Guide
41
8
If your network is configured for wireless 802.11, tap the System tab
and tap Wireless Network.
and tap Wireless Network.
9
Choose a profile and tap Edit Selected Profile.
10
Edit the profile settings to match your network. This includes the SSID
(network name) of your access point(s) and any security settings
associated with your wireless network.
(network name) of your access point(s) and any security settings
associated with your wireless network.
11
Tap the OK button near the bottom of the screen. Tap it again when the
next screen appears.
next screen appears.
12
To exit the Control Panel, tap the X button in the upper right corner of
the screen.
the screen.
13
Perform the steps in one of the next two procedures to configure
dcBrowser for either TCP/IP or UDP Plus.
dcBrowser for either TCP/IP or UDP Plus.
To configure dcBrowser for TCP/IP on the Intermec computer
1
Select Start > Settings. The Control Panel appears.
2
Tap the System tab.
3
Tap Intermec Settings > Communications >UDP Plus.
4
Make sure that the UDP Plus Activate check box is not checked.
5
Tap the X button in the upper right corner of the screen. If you made a
change, the “Save configuration changes?” prompt appears. Tap Yes to
save the changes.
change, the “Save configuration changes?” prompt appears. Tap Yes to
save the changes.
6
To close Intermec Settings, tap the X button in the upper right corner of
the screen.
the screen.
7
Perform the steps in the section,
To configure dcBrowser for UDP Plus on the Intermec computer
1
Select Start > Settings. The Control Panel appears.
2
Tap the System tab.
3
Tap Intermec Settings > Communications >UDP Plus.
4
Tap UDP Plus Activate until a check appears in the check box.
5
Tap Controller IP. An edit box appears. Tap inside the edit box and
type the IP address for the controller. Tap outside the edit box to close
it.
type the IP address for the controller. Tap outside the edit box to close
it.
6
Tap Controller Port if you need to change the port number (which
defaults to 5555) to match the port configured for UDP Plus on the
controller. An edit box appears. Tap inside the edit box and type the
port number. Tap outside the edit box to close it.
defaults to 5555) to match the port configured for UDP Plus on the
controller. An edit box appears. Tap inside the edit box and type the
port number. Tap outside the edit box to close it.
Note: When you start the dcBrowser client for the first time, you will be
prompted for an IP address and port number.
prompted for an IP address and port number.