Intermec 9710 参照ガイド

C d 39

This section covers these workstations: 

•  Bull DKU 7102 
•  Bull DKU 7104 
•  Bull DKU 7105 
•  Bull DKU 7107 

The individual Wedge Interface Guide corresponding to this section is part number 
054275. 

Connecting the reader to one of these workstations requires two cables: a keyboard 
cable and a terminal cable. The interface kit contains both the keyboard and terminal 
cables. If you need to order a replacement cable, use the part numbers listed below: 

•  Wedge interface kit (P/N 054274) 
•  Keyboard cable (P/N 054273) 
•  Terminal cable (P/N 054272) 

The reader does not require an external power supply to work with this workstation. Set 
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel. 

Scan this label to configure the reader for your workstation. After the label is scanned, 
the reader emits one low beep followed by four low beeps. The four low beeps indicate 
the reader has successfully stored the configuration and is ready to read labels. If the 
reader emits a different beep sequence, refer to the Wedge Reader User’s Manual, 
Section 2, for beeper identification. 

Bull DKU 7102, 7104, 7105, 7107 

*$+TA113* 

*$+TA113*