Intermec 9710 参照ガイド

C d 39

This section covers these workstations: 

•  Idea Courier 12471 
•  Idea Courier 12472-01C 

The individual Wedge Interface Guide for this section is part number 059308. 

Connecting the reader to one of these workstations requires two cables: a keyboard 
cable and a terminal cable. The interface kit contains both the keyboard and terminal 
cables. If you need to order a replacement cable, use the part numbers listed below: 

•  Wedge interface kit (P/N 059309) 
•  Keyboard cable (P/N 057470) 
•  Terminal cable (P/N 057471) 

If you use a 15XX laser scanner with these workstations, the reader requires an external 
power supply. Set the PCB jumper to connect pins 2 and 3 on the reader’s rear panel. 

If you use a wand with these workstations, the reader uses workstation power. Set the 
PCB jumper to connect pins 1 and 2. 

Scan this label to configure the reader for your workstation. After the label is scanned, 
the reader emits one low beep followed by four low beeps. The four low beeps indicate 
the reader has successfully stored the configuration and is ready to read labels. If the 
reader emits a different beep sequence, refer to the Wedge Reader User’s Manual, 
Section 2, for beeper identification. 

 

Note: This interface uses the standard Twinax/Coax keyboard mapping (Table A-2, in 
the Wedge Reader User’s Manual). 

Idea Courier 
US Keyboard (model 701920-001) 

*$+TA202* 

*$+TA202*