Intermec 9710 参照ガイド
C d 39
Macintosh II and SE Series
59
Macintosh II and SE Series
This section covers these workstations:
• Macintosh SE
• Macintosh II
• Macintosh II
The individual Wedge Interface Guide corresponding to this section is part number
054842.
054842.
Cables
Connecting the reader to one of these workstations requires a terminal cable. The
expansion cable is required when connecting other input devices (for example, a
mouse). The interface kit contains both the expansion and terminal cables. If you need
to order a replacement cable, use the part numbers listed below:
expansion cable is required when connecting other input devices (for example, a
mouse). The interface kit contains both the expansion and terminal cables. If you need
to order a replacement cable, use the part numbers listed below:
• Wedge interface kit (P/N 054841)
• Expansion cable (P/N 054840)
• Terminal cable (P/N 054839)
• Expansion cable (P/N 054840)
• Terminal cable (P/N 054839)
Power Supply
The reader does not require an external power supply to work with the workstations. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
US and United Kingdom Keyboard
*$+TA175*
*$+TA175*
Danish Keyboard
*$+TA178*
*$+TA178*