IBM R30 補足マニュアル

Click OK to disable DMA for the infrared port.

Close a parallel port panel.

Click the Infrared device button to open the infrared panel.

Choose DMA0 or DMA1 for the infrared port on the panel.

If you see the panel asked whether you want to disable DMA for an audio
device, click OK.

Standby or hibernation problems

Problem:

The computer enters standby mode automatically.

Solution:

If the processor reaches a temperature that is too high, the computer

will automatically enter standby mode to allow the computer to cool and to
protect the processor and other internal components.

Problem:

The computer enters standby mode immediately after POST (the

standby indicator turns on).

Solution:

Make sure that:

v The battery is charged.
v The operating temperature is within the acceptable range. Refer to

“Specifications” in this Guide.

If these items are correct, have the computer serviced.

Problem:

The

critical low-battery error appears, and the computer

immediately turns off.

Solution:

The battery power is getting low. Connect the ac adapter to the

computer, or replace the battery with a fully charged one.

Problem:

The computer display remains blank after you take action to return

from a sleep mode.

Solution:

Check if an external monitor was disconnected while the computer

was in standby mode. Do not disconnect the external monitor while the
computer is in standby mode or hibernation mode. If no external monitor is
attached when the computer resumes, the computer display remains blank
and output is not displayed. This restriction does not depend on the
resolution value

Problem:

The computer does not return from standby mode, or the standby

indicator stays on and the computer does not work.

Solution:

The computer automatically enters standby or hibernation mode

when the battery is depleted. Do one of the following:

Solving computer problems

Chapter 2. Solving computer problems