Adaptec rs ユーザーガイド
3-10
Cabling and Configuration
Connecting a Power Source
This disk shelf is available in an AC power source configuration. The following
sections describe how to connect the power source to the disk shelf.
sections describe how to connect the power source to the disk shelf.
Connecting an AC Power Source
Figure 3-6. Location of AC power receptacle
1.
Ensure the power switch on the disk shelf is in the off position.
2.
Connect both the power cords to the disk shelf by inserting the power cords
into the power receptacles on the rear of the disk shelf (see ).
into the power receptacles on the rear of the disk shelf (see ).
3.
Plug the other end of the power cord into a properly grounded AC power
source.
source.
4.
Turn on the power switch to power up the system.
Fuses
There are two fuses located on the Power Module of the AC systems. The fuse
can be accessed by using a screwdriver to open the fuse cover.
can be accessed by using a screwdriver to open the fuse cover.
WARNING: Ensure the power switch is set to OFF and the power cords
removed before opening the fuse covers.
removed before opening the fuse covers.
The fuse must be rated for 16 AMPS.
Mute
T
emp
SCSI Out
SCSI In
LV
D
SE
PSU 1
0
1
PSU 2 PSU 1
AC Power
Recepticles
Recepticles
VEM Host Shelf
2 0/1
1
2
1
2