McCall dt1-102401e 仕様ガイド

Cabinet - Cabinets are all metal, inside and out. The
top, back, and bottom are made of galvanized steel. In
addition, all seams are closed and sealed, with metal
edges turned away from the exposed surface. The
result is an integrated structural frame. Internal corners
are coved to conform to NSF standards. Automatic
interior lighting is controlled by a light switch concealed
in the door hinge. The cabinet is supported on four 6
inch adjustable steel legs.

Doors - Constructed of metal, refrigerator doors are
self-closing and fully insulated. Their cam-lift hinges are
chrome-plated and self-lubricating. Hinges also have a
safety stop that holds the door open, preventing
overswing. Chrome-plated pull handles have built-in
cylinder locks. The full-perimeter, magnetic vinyl
gaskets are removable without the use of tools. Doors
easily lift off, and door perimeters have a built-in, low
wattage, and anti-condensate heater. Door openings are
protected by an impact-resistant, nonconductive PVC
breaker strip with no exposed screws or fasteners.

Insulation - Cabinet body, doors, and evaporator 
coil housings are filled with pressure-injected
polyurethane foam.

Interior Shelves - Three wire shelves per section are
standard. Shelves have a runner spaced 3/4 inch O.C.
with two reinforcing bars 8 1/2 inch O.C. Coated with 7
mils of baked-on gray epoxy. The shelves have a saline
spray corrosion resistance of 600 hours. Shelves will
support 250 pounds each with maximum cabinet load
of 800 lbs. They are supported on stainless steel
pilasters, and are adjustable on 1 inch centers. All three
shelves are interchangeable and can be adjusted
without tools or special parts.

Self-Contained Refrigeration - Has interior evaporator
coils. Refrigeration components includes hermetically
sealed compressors, receiver tanks, the thermostatic
expansion valves, thermostatic temperature controls,
high-humidity evaporator coils and electrical
condensate evaporator pans. The refrigerator system is 

balanced to maintain 38°F average internal air
temperature. The freezer system is balanced to
maintain 0°F average internal air temperature. 
The air distribution system provides even air flow 
and temperature control throughout the cabinet. All
components are factory installed and tested, and
supplied with master power switch, and exterior 
digital thermometer.

Remote Cabinets - Standard remote units are provided
with capped refrigeration lines, expansion valves,
solenoid valves, electric condensate evaporators,
and temperature controls. Condensing units are not
included. All other features are the same as self-
contained units, except no power cord.

• Top mounted compressor 
• Expansion valve  
• Cord and plug (see electrical section) 
• R-134a refrigerant (refrigerator) 
• R-404A refrigerant (freezer) 
• Exterior digital thermometer (1000 series) dial thermometer (2000-4000 series) 
• Self-closing cam-lift hinges 
• Chrome-plated door handles with security locks 
• 6 inch adjustable legs 
• Stainless steel shelf supports 
• Baked epoxy-coated shelves adjustable on 1 inch centers 
• Magnetic door gaskets 

McCall Refrigeration specification sheets are available 
online @ www.mccallrefrigeration.com

Stainless steel cabinet interior and exterior front, sides and doors.

CLASSIFIED TO

NSF (STD-7-1999)